NSN 5905-00-951-8063

Datasheet

• Product description
  

  Nonprecision Wire Wound Variable Resistor NSN 5905-00-951-8063.

• MPN or Model
  

  335C779H010

• Schedule B
  8533.39.0080 (Wirewound variable resistors, nesoi)
• NMF (National Motor Freight)
  062960 - Reostats/parts NOI
• Section Quantity
  1
• Body Style
  Rectangular w/mounting holes/slots
• Reliability Indicator
  Not established
• Overall Length
  Between 1.281 inches and 1.345 inches
• Terminal Length
  Between 0.484 inches and 0.516 inches
• Overall Height
  Between 0.780 inches and 0.844 inches
• Overall Width
  Between 0.270 inches and 0.290 inches
• Mounting Hole Diameter
  0.088 inches
• Shaft Diameter
  0.125 inches
• Shaft Length
  Between 0.047 inches and 0.079 inches
• Body Length
  Between 1.234 inches and 1.266 inches
• Body Width
  Between 0.270 inches and 0.290 inches
• Body Height
  Between 0.296 inches and 0.328 inches
• Shaft Style
  Round, slotted
• Actuator Type
  Single shaft
• Center To Center Distance Between Terminals
  Between 0.690 inches and 0.710 inches
• Lateral Distance Between Mounting Hole Centers
  Between 0.995 inches and 1.005 inches
• Mounting Facility Quantity
  2
• Terminal Location
  Radially positioned over less than half the circumference
• Mounting Method
  Unthreaded hole
• Electrical Resistance Per Section
  10.000 kilohms single section
• Center To Center Distance Between Center Terminal And Outside Terminal
  Between 0.290 inches and 0.310 inches
• Ambient Tempurature In Deg Celsius Per Section At Zero Percent Rated Power
  175.0 single section
• Tempurature Coefficient Of Resistance Per Section In Ppm Per Deg Celsius
  -70.0/+70.0 single section
• Power Dissipation Rating Per Section In Watts
  1.0 free air single section
• Resistance Tolerance Per Section In Percent
  -10.0/+10.0 single section
• Ambient Tempurature In Deg Celsius Per Section At Full Rated Power
  70.0 single section
• Standard Taper Curve Per Section
  A single section
• Test Data Document
  19315-335c779 drawing (this is the basic governing drawing, such as a contractor drawing, original equipment manufacturer drawing, etc.; excludes any specification, standard or other document that may be referenced in a basic governing drawing)
• Terminal Type And Quantity
  3 pin
• Reference Number Differentiating Characteristics
  As differentiated by quality controlled for polaris