NSN 5305-00-434-9836
High Torque Screw
Between 1.545 inches and 1.592 inches fastener length, 260000 pounds per square inch min. tensile strength (psi), steel material, material specification: sps-m-107, standard pressed steel co mfr ref single material response .
Manufacturer part number SFH26-8A16 for national stock number 5305004349836.
Datasheet
-
Product description
Close Tolerance Screw NSN 5305-00-434-9836.
-
MPN or Model
SFH26-8A16
-
Schedule B
7318.15.2000 (Bolts and bolts and their nuts or washers exported in the same shipment) -
NMF (National Motor Freight)
093486 - Bolts, Nuts Or Screws, NOI (sub 3) -
Unit Weight (Est.)
0.1 lb -
Thread Class
3a -
Thread Length
Between 0.535 inches and 0.602 inches -
Fastener Length
Between 1.545 inches and 1.592 inches -
Min. Tensile Strength (psi)
260000 pounds per square inch -
Material
Steel -
Material Specification
Sps-m-107, standard pressed steel co mfr ref single material response -
Specification Data
26512-gb510m manufacturers standard
More from these suppliers
- 5930-00-001-7399 MPN GS836BU2-1Toggle Switch
- 5935-00-014-5830 MPN GS21A1Plug-in Electronic Components Socket
- 4820-00-021-3696 MPN 89SP1132Directional Control Linear Valve
- 5905-00-021-9115 MPN 134AV25020-7Nonprecision Wire Wound Variable Resistor
- 1560-00-098-0976 MPN 89WM2105-1Aircraft Structural Component Support
- 5985-00-141-5895 MPN 128SCSEA715-5Radio Frequency Transmission Line Switch
- 1560-00-145-8295 MPN A51B35002-27Aircraft Leading Edge
- 1560-00-185-9415 MPN 1128CEM40105-11Fitting Canopy Channel
A screw, machine or screw, cap, socket head whose unthreaded portion is of specified grip length, plated or unplated, and is machined to a tolerance of one thousandth (0.001 in.) (0.025 mm) or less of a specific diameter for items (1.000 in.) (25 mm) or less in diameter. Items over (1.000 in.) (25 mm) in diameter shall have a tolerance of fifteen ten thousandths (0.0015 in.) (0.038 mm) or less. The nominal major diameter of the threads shall be at least one thousandth (0.001 in.) (0.025 mm) below the minimum shank diameter, but not below the minimum major diameter for applicable class of fit, as shown in the screw thread standards, fed std h28 and/or other nationally recognized standards. The head is designed to be held or driven with an inserted driver. It is not designed for rotation by the thumb and fingers. A locking feature may be incorporated in the design of the head or threads.
Pricing and Availability
Get a quote for 5305-00-434-9836 close tolerance screwManufacturer Part Numbers and Alternates
MPN manufacturer part number | Registrant or Supplier |
---|---|
SFH26-8A16 | Sps Technologies, Llc |
SFH26-8A16 | Sps Technologies, Llc |
GB510M8A16 | Northrop Grumman Systems Corporation |