NSN 5305-01-342-9434
High Torque Screw
0.653 inches fastener length, flat countersunk head style, between 0.390 inches and 0.410 inches head diameter, grip diameter: between 0.248 inches and 0.249 inches .
Manufacturer part number 7002820-4 for national stock number 5305013429434.
Datasheet
-
Product description
Close Tolerance Screw NSN 5305-01-342-9434.
-
MPN or Model
7002820-4
-
Schedule B
7318.15.2000 (Bolts and bolts and their nuts or washers exported in the same shipment) -
NMF (National Motor Freight)
093486 - Bolts, Nuts Or Screws, NOI (sub 3) -
Unit Weight (Est.)
0.1 lb -
Thread Class
3a -
Thread Direction
Right-hand -
Thread Length
0.435 inches -
Fastener Length
0.653 inches -
Head Style
Flat countersunk -
Head Diameter
Between 0.390 inches and 0.410 inches -
Grip Diameter
Between 0.248 inches and 0.249 inches -
Internal Drive Style
Offset cruciform (torque set) -
Thread Diameter
0.250 inches -
Grip Length
0.218 inches -
Thready Qty Per Inch (tpi)
28 -
Min. Tensile Strength (psi)
160000 pounds per square inch -
Countersink Angle
Between 99.0 degrees and 101.0 degrees -
Material
Steel comp 4140 -
Surface Treatment
Cadmium -
Thread Series Designator
Unjf
More from these suppliers
- 5905-00-104-8334 MPN 4171300-058Composition Fixed Resistor
- 5985-00-438-4018 MPN 928090-1Radio Frequency Reflection Isolator
- 5905-00-503-5508 MPN 4171405-291Film Fixed Resistor
- 5935-00-534-3234 MPN 970653-2Electrical Connector Retainer
- 5905-00-583-0520 MPN 4171588-019Inductive Wire Wound Fixed Resistor
- 5930-00-586-7036 MPN 721899-100Thermostatic Switch
- 4820-00-618-7820 MPN 651346Safety Relief Valve
- 5905-00-701-0031 MPN 719299-005Wirewound Fixed Resistor Network
A screw, machine or screw, cap, socket head whose unthreaded portion is of specified grip length, plated or unplated, and is machined to a tolerance of one thousandth (0.001 in.) (0.025 mm) or less of a specific diameter for items (1.000 in.) (25 mm) or less in diameter. Items over (1.000 in.) (25 mm) in diameter shall have a tolerance of fifteen ten thousandths (0.0015 in.) (0.038 mm) or less. The nominal major diameter of the threads shall be at least one thousandth (0.001 in.) (0.025 mm) below the minimum shank diameter, but not below the minimum major diameter for applicable class of fit, as shown in the screw thread standards, fed std h28 and/or other nationally recognized standards. The head is designed to be held or driven with an inserted driver. It is not designed for rotation by the thumb and fingers. A locking feature may be incorporated in the design of the head or threads.
Pricing and Availability
Get a quote for 5305-01-342-9434 close tolerance screwManufacturer Part Numbers and Alternates
MPN manufacturer part number | Registrant or Supplier |
---|---|
7002820-4 | Raytheon Company |