NSN 5305-01-452-3820
High Torque Screw
Oversize grip dia.
Manufacturer part number LD111-0046-2406 for national stock number 5305014523820.
Datasheet
-
Product description
Close Tolerance Screw NSN 5305-01-452-3820.
-
MPN or Model
LD111-0046-2406
-
Schedule B
7318.15.2000 (Bolts and bolts and their nuts or washers exported in the same shipment) -
NMF (National Motor Freight)
096640 - Screws, Iron Or Steel -
Thread Class
3a -
Thread Direction
Right-hand -
Thread Length
0.397 inches -
Fastener Length
Between 0.757 inches and 0.787 inches -
Head Style
Flat countersunk -
Head Diameter
Between 0.464 inches and 0.506 inches -
Grip Diameter
Between 0.2802 inches and 0.2807 inches -
Internal Drive Style
Offset cruciform (torque set) -
Thread Diameter
0.250 inches -
Grip Length
0.375 inches -
Thready Qty Per Inch (tpi)
28 -
Countersink Angle
Between 99.0 degrees and 101.0 degrees -
Material
Steel comp xm-13 -
Surface Treatment
Passivate -
Surface Treatment Specification
Qq-p-35 federal specification single treatment response -
Thread Series Designator
Unjf
More from these suppliers
- 1680-00-040-8290 MPN 191-31717-15Radio Door Access Cable Assembly
- 1560-00-124-7718 MPN 55-44008Bellcrank Assemblyx
- 1560-00-675-4997 MPN 165-54128Resistor Panel Assy
- 5905-00-694-4288 MPN 151-71048Composition Fixed Resistor
- 1680-00-792-7674 MPN 246-33723Emerge Support Assy
- 1560-01-163-8410 MPN L5340036-003Aircraft Structural Component Support
- 1560-01-175-1984 MPN L4800231-011Aircraft Fluid Manifold
- 1560-01-179-8273 MPN L3004140-021Aircraft Access Cover
A screw, machine or screw, cap, socket head whose unthreaded portion is of specified grip length, plated or unplated, and is machined to a tolerance of one thousandth (0.001 in.) (0.025 mm) or less of a specific diameter for items (1.000 in.) (25 mm) or less in diameter. Items over (1.000 in.) (25 mm) in diameter shall have a tolerance of fifteen ten thousandths (0.0015 in.) (0.038 mm) or less. The nominal major diameter of the threads shall be at least one thousandth (0.001 in.) (0.025 mm) below the minimum shank diameter, but not below the minimum major diameter for applicable class of fit, as shown in the screw thread standards, fed std h28 and/or other nationally recognized standards. The head is designed to be held or driven with an inserted driver. It is not designed for rotation by the thumb and fingers. A locking feature may be incorporated in the design of the head or threads.
Pricing and Availability
Get a quote for 5305-01-452-3820 close tolerance screwManufacturer Part Numbers and Alternates
MPN manufacturer part number | Registrant or Supplier |
---|---|
LD111-0046-2406 | Boeing Company, The |
Stock Check
- NE: 3003