NSN 5305-01-483-8268
High Torque Screw
Between 0.828 inches and 1.040 inches fastener length, flat countersunk head style, 0.455 inches head diameter, grip diameter: between 0.3115 inches and 0.3120 inches .
Manufacturer part number BACB30DL4C10 for national stock number 5305014838268.
Datasheet
-
Product description
Close Tolerance Screw NSN 5305-01-483-8268.
-
MPN or Model
BACB30DL4C10
-
Schedule B
7318.15.2000 (Bolts and bolts and their nuts or washers exported in the same shipment) -
Thread Class
3a -
Thread Direction
Right-hand -
Thread Length
0.425 inches -
Fastener Length
Between 0.828 inches and 1.040 inches -
Head Style
Flat countersunk -
Head Diameter
0.455 inches -
Grip Diameter
Between 0.3115 inches and 0.3120 inches -
Single Shear Strength
125000 pounds per square inch -
Internal Drive Style
Recessed type i -
Thready Qty Per Inch (tpi)
28 -
Countersink Angle
100.0 degrees -
Material
Steel comp xm-13 -
Thread Series Designator
Unjf
More from these suppliers
- 1560-00-012-1577 MPN 65-22442-2High Pressure Supp Duct Assembly
- 1680-00-056-6162 MPN 5-87405-22 Mechanism Assembly
- 1680-00-064-9202 MPN 114C1137-3Pedal Adj Guide Pin
- 1560-00-098-7239 MPN 6-45877Antifriction Seal Ring
- 1560-00-340-4313 MPN 90-2425-2Flap Drive Shaft Assembly
- 5935-00-348-3590 MPN BACR10AC22Electrical Connector Retaining Plate
- 1560-00-568-3439 MPN 9-35795-1Aircraft Structural Component Support
- 1560-00-621-4694 MPN 9-37008-20Escape Bearing Assembly
A screw, machine or screw, cap, socket head whose unthreaded portion is of specified grip length, plated or unplated, and is machined to a tolerance of one thousandth (0.001 in.) (0.025 mm) or less of a specific diameter for items (1.000 in.) (25 mm) or less in diameter. Items over (1.000 in.) (25 mm) in diameter shall have a tolerance of fifteen ten thousandths (0.0015 in.) (0.038 mm) or less. The nominal major diameter of the threads shall be at least one thousandth (0.001 in.) (0.025 mm) below the minimum shank diameter, but not below the minimum major diameter for applicable class of fit, as shown in the screw thread standards, fed std h28 and/or other nationally recognized standards. The head is designed to be held or driven with an inserted driver. It is not designed for rotation by the thumb and fingers. A locking feature may be incorporated in the design of the head or threads.
Pricing and Availability
Get a quote for 5305-01-483-8268 close tolerance screwManufacturer Part Numbers and Alternates
| MPN manufacturer part number | Registrant or Supplier |
|---|---|
| BACB30DL4C10 | The Boeing Company |
| BACB30DL4-10 | The Boeing Company |
Stock Check
