NSN 5305-01-545-4649
High Torque Screw
Between 0.722 inches and 0.752 inches fastener length, flat countersunk head style, between 0.497 inches and 0.507 inches head diameter, locking feature: pellet threads.
Manufacturer part number NAS1164E5N for national stock number 5305015454649.
Datasheet
-
Product description
Close Tolerance Screw NSN 5305-01-545-4649.
-
MPN or Model
NAS1164E5N
-
Schedule B
7318.15.2000 (Bolts and bolts and their nuts or washers exported in the same shipment) -
NMF (National Motor Freight)
096640 - Screws, Iron Or Steel -
Thread Class
3a -
Thread Direction
Right-hand -
Thread Length
0.425 inches -
Fastener Length
Between 0.722 inches and 0.752 inches -
Head Style
Flat countersunk -
Head Diameter
Between 0.497 inches and 0.507 inches -
Locking Feature
Pellet threads -
Grip Diameter
Between 0.248 inches and 0.249 inches -
Internal Drive Style
Offset cruciform (torque set) -
Thread Diameter
0.250 inches -
Grip Length
0.312 inches -
Thready Qty Per Inch (tpi)
28 -
Countersink Angle
Between 99.0 degrees and 101.0 degrees -
Material
Plastic locking feature -
Thread Series Designator
Unjf
More from these suppliers
- 5935-00-076-1629 MPN 2271068Plug-in Electronic Components Socket
- 5905-00-189-2483 MPN 1621591PC3Film Fixed Resistor
- 4820-00-288-7836 MPN 313-4900-233405PCV1140Safety Relief Valve
- 4820-00-288-7842 MPN 349-2200-483696PCV9189Safety Relief Valve
- 4820-00-288-8602 MPN BB61S47-01PC121Plug Cock
- 1680-00-304-5895 MPN 52A315C2A Fixed Leg Fitting
- 5935-00-328-1135 MPN 3234220-1Electrical Receptacle Connector
- 5930-00-892-9479 MPN 2660124Push Switch
A screw, machine or screw, cap, socket head whose unthreaded portion is of specified grip length, plated or unplated, and is machined to a tolerance of one thousandth (0.001 in.) (0.025 mm) or less of a specific diameter for items (1.000 in.) (25 mm) or less in diameter. Items over (1.000 in.) (25 mm) in diameter shall have a tolerance of fifteen ten thousandths (0.0015 in.) (0.038 mm) or less. The nominal major diameter of the threads shall be at least one thousandth (0.001 in.) (0.025 mm) below the minimum shank diameter, but not below the minimum major diameter for applicable class of fit, as shown in the screw thread standards, fed std h28 and/or other nationally recognized standards. The head is designed to be held or driven with an inserted driver. It is not designed for rotation by the thumb and fingers. A locking feature may be incorporated in the design of the head or threads.
Pricing and Availability
Get a quote for 5305-01-545-4649 close tolerance screwManufacturer Part Numbers and Alternates
MPN manufacturer part number | Registrant or Supplier |
---|---|
NAS1164E5N | National Aerospace Standards |
6391094 FIND 034 | Naval Sea Systems Command |